Step 4: Install Mounting Bracket; Step 5: Install The Hood - GE ZV750SY Installation Instructions Manual

4
Whenever possible, the vent hood should be
Step
secured to the wall studs.
When screws enter wall studs:
Install
• Drill 1/8" pilot holes at the 6 locations shown
Mounting
• Remove the template.
Brackets
• Secure the mounting brackets to the wall
When screws enter a hollow wall:
• Drill 3/8" pilot holes at the 6 locations shown
• Remove the template.
• Tap the anchors for the molly bolts into all 6
• Secure the mounting brackets to the wall
• Tighten screws until molly bolts expand
5
Place the hood on the brackets and slide left
to right to align with rectangular slots at the
S tep
top.
• Adjust the installation height by tightening
Install
the Hood
• Align the hood to match lower mounting
• Install wood screws or molly bolts, loosely,
• Level the hood by tightening or loosening
• Tighten the lower mounting screws.
• Tighten the screws located at the top of the
on the template.
with wood screws provided.
on the template.
pilot holes.
with screws.
behind the dr ywall.
or loosening the screws at the bottom of the
brackets.
holes with pilot holes.
into lower mounting holes. Do not tighten.
the screws located on the bottom mounting
brackets.
mounting bracket against the hood.
Installation
36" Vent Hood
Some installations may use a combination of mounting the hood
Note:
to studs and to hollow wall. Drill 1/8" pilot holes in all locations.
Enlarge holes that did not enter studs to 3/8" and tap anchors for molly
bolts into the holes.
Tighten Screws
To Secure Hood
Mounting Screws
To Wall
Level and
Height
Adjustment
Screws
8