Connecting The Fm And Am Antennas - JVC RX-DVSSL Instructions Manual

Getting Start
Snap the tabs on the loop into
the slots of the base to
assemble the AM loop antenna
f AM reception is poor,
:onnect an outdoor
jingle vinyl-covered wire
:not supplied).
If FM reception is poor, connect
I
outdoor FM antenna (not supplied).
I
ANTENNA -
AM
antenna connection
Connect the AM loop antenna supplied to the AM LOOP
terminals.
1 Remove the insulation if the AM loop antenna
wire is covered with vinyl.
2 Press and hold the clamp of the terminal (a),
then insert the wire (a).
3 Release the clamp.
rum the loop until you have the best reception.
p If the reception is poor, connect an outdoor single vinyl-
covered wire (not supplied) to the AM EXT terminal. Keep the
AM loop antenna connected.
Rear panel of the unit
FM
antenna connection
Connect the FM antenna supplied to the FM 75 Q COAXIAL
terminal as temporary measure.
Extend the supplied FM antenna hot-irontally.
l
If the reception is poor. connect an outdoor FM antenna (not
with a coaxial type
connector, disconnect the supplied FM antenna.
Note:
l
Make sure the antenna conductors do not touch any other
termfnals, connecting cords and power cord. This could
cause
poor
reception.
5