Table of Contents
Advertisement
I
Troubles
Use this chart to help you solve daily operational problems. If there is any problem you cannot \olvc. contact qour dealer.
W Genaral
PROBLEM
The power does not come on.
No sound from speakers.
POSSIBLE
CAUSE
The power cord is not plugged in.
Speaker signal cables are not
connected.
The audio cable i< not connected
properly.
An incorrect source is selected.
Sound from one speaker only.
Muting is activated.
An incorrect input mode (analog 01
digital) is selected.
Connections are incorrect.
The balance IS \et to one extreme
"OVERLOAD"
starts flashing on the
display.
Speakers are overloaded because ot
high volume.
The STANDBY
lamp lights up after
turning on the power, hut soon the unit
turns off (into standby mode).
Speakers are overloaded because of
short circuit of speaker terminals.
The unit is overloaded hecause of a
high voltage.
Remote control does not operate as you
intend.
Remote control does not work.
The remote control is not ready for
your intended operation.
It is too far from the unit. or is not
facing the unit.
There is an obstruction hiding the
remote sensor on the unit.
The remote control I\ not aimed at the
remote sensor- on the unit 01
components.
The batteries have been inserted into
the wrong way round (+/-).
Batteries are weak.
The remote control signals are not set
correctly.
SOLUTION
Plug the power cord into an AC outlet.
Cheek spcakcr wiring and reconnect if
necessary.
Connect the cord pl-operly (see pages 7 to
IO).
Select the concct source.
Press MUTING to cancel the muting.
Select rhc correct input mode (analog 01.
digital).
Check connection\.
Ad,iust the balance properly (\ee pages 24 01
52).
I. Pres\ O/I STANDBY/ON
on the front
panel to turn 00' the unit.
2. Stop the playback source.
3. Turn on the unit again. and ad-just the
Press Oil STANDBY/ON
on the front panel
to turn off the unit. then check the ypeaket
wil-ing.
If "OVERLOAD"
does not disappear.
unplug the AC power cord. then plug it bath
again.
If 5pcaLcr uiring i\ not short-circuited.
COIl1;LC1
you,- deale1-.
Press Oil STANDBY/ON
on the front panel
to turn off the unit. After unplugging the
power cord. consult your dealer.
PI-es? CONTROL, (\ee page 24) or a source
selecting button first. then press the buttons
you want to use.
Come clo\er to the unit. Operate the remote
control within 73 ft (7 m) II-om the unit.
Remove the oh\tt-uction.
Aim the rcmolc control at the remote scnsot
on e;lc,h componrrr1 you want to operate.
Replocc hatterie\.
Enter the corl-ccl nl;uiufilctllrcra'
code (set
pages 63 to 6.5).
67
Advertisement
Table of Contents
