Operating Video Components - JVC RX-DVSSL Instructions Manual

To operate JVC's video components using this remote control
l
You need to connect JVC's \idco components through the
AV COMPU LINK-III jacha (\ec page SC)) in addition to the
audio/video connections (vx papc\ 7 to IO).
0 Some JVC's VCRs can accept two types of the control signals-
remote codes "A" and "R." Before using this remote control, make
sure that the remote control code of the connected VCR is set to
code "A."
l
To operate the video component(\) using the remote control, aim
the remote control directly at the remote sensor on each
component. not on this unit.
q
w
You can always perform the follo\h ing operations:
O/I STANDBY/ON TV
: Turns on or off the TV.
TV VOI, + or - : Adjusts the volume.
TV/VIDEO : Se& the input mode (either TV 01
VIDEO).
After pressing TV, you can perform the following operations on a TV:
TV/DBS CH + or - : Change\ the channels.
1 - 9,0, lOO+ : Selects the channels.
For channel number 5. press 5.
For channel number IO, press I, then 0.
FOI- channel number 23. press 2, then 3.
For channel number 135, press lOO+, 3.
then S.
TV RETURN : Alternate\ between the previously
{elected channel and the current
channel.
n
VCR
You can always perform the following operations:
Ii .
Oil STANDBY/ON VCR : Turns on or off the VCR
After pressing VCR, you can perform the following operations on a
VCR:
1 -- 9, 0 : Selects the TV channels on a VCR.
For channel number 5, press 5.
For channel number 10, press 1, then 0.
For channel number 23, press 2, then 3
b
: Starts playing.
REW
: Rewinds a tape.
FF
: Fast-winds a tape.
n
: Stops operations.
II : Pauses playing. To release it, press ).
62