Ford EXPEDITION 2014 Owner's Manual page 375

374
Turning the Device On and Off
1. Pivot the screen downward until you reach a comfortable viewing
angle.
2. Press POWER on the lower-left corner of the front panel or on the
remote control. The controls illuminate when the system is in use.
3. When the device is on and is displaying a picture, pivot the screen to
change the viewing angle to optimize the picture quality.
4. Remember to turn the device off and pivot the LCD panel to the
locked position when not in use.
DVD Basics
To get the most use out of each DVD, make sure you read this section
completely.
Regional Coding
Both the DVD player and disc have specific region codes. These regional
codes must match in order for the disc to play. If the codes do not
match, the disc does not play. The system is set to the region code
designated for your area by the DVD Copy Control Association. Other
regions do not play in this system.
Loading and Playing Discs
When you press POWER, the system turns on in DVD mode. Place the
disc about halfway into the disc compartment slot, with the disc's label
facing the rear of your vehicle. Insert the disc straight into the player; do
not insert the disc at an angle.
The disc loads automatically and begins to play. Some discs start at the
root menu, where you have to select disc play manually.
Depending on the disc and playback location on the disc, the icon may
display in the upper-left corner of the screen indicating that still
playback is not possible.
Notes
• To keep a disc clean, do not touch its surface. Handle the disc by its
edge.
• Keep your discs in their cases or disc magazines when not in use.
Also, do not subject a disc to heat or high temperatures. Avoid
leaving them in a parked vehicle, on a dashboard or on a rear tray.
• Do not attach labels, or use discs with sticky ink or residue. Such discs
may stop spinning, causing a system malfunction, or ruining the disc.
2014 Expedition (exd)
Owners Guide gf, 2nd Printing, November 2013
USA (fus)
Audio System