Checking The Wiper Blades - Ford EXPEDITION 2014 Owner's Manual

Hide thumbs Also See for EXPEDITION 2014:

Table of Contents

3. Run the engine until it reaches normal operating temperature.

4. Allow the engine to idle for at least one minute.

5. Turn the A/C on and allow the engine to idle for at least one minute.

6. Drive the vehicle to complete the relearning process.

• The vehicle may need to be driven 10 miles (16 km) or more to

relearn the idle and fuel trim strategy.

• Note: If you do not allow the engine to relearn its idle trim, the idle

quality of your vehicle may be adversely affected until the idle trim is

eventually relearned.

If the battery has been disconnected or a new battery has been installed,

the clock and radio settings must be reset once the battery is

reconnected.

CHECKING THE WIPER BLADES

Run the tip of your fingers over the edge of the blade

to check for roughness.

Clean the wiper blades with washer fluid or water

applied with a soft sponge or cloth.

2014 Expedition (exd)

Owners Guide gf, 2nd Printing, November 2013