JUMPER TYPE
FC to LC
SC TO LC
LC TO LC
OC3 AUX Interface Board Connections
A.2.7
Wayside DS1 Terminal
A.2.7.1
Recommended connectorized cable assembly – PN 695-4125-041 (26 AWG 5 pair shielded,
jacketed cable with 9-pin D-type connector on one end). See Figure A-9 for location.
Wayside DS1 Repeater
A.2.7.2
Recommended connectorized cable assembly – PN 695-4125-051 (26 AWG 5 pair shielded,
jacketed cable with 9-pin D-type connector on each end). See Figure A-9 for location.
OC3 Repeater Cable Connections
A.2.7.3
The OC3 radio repeater cable carries wayside clocks, data, and over-
head for two directions. It does not carry OC3 traffic. OC3 fiber optic
cables must be run separately. If the repeater cable is not used, the
embedded data in the overhead must also be cabled individually. In
this case, separate cables must be run for MCS-11, audio, RS-232, and
ELMC.
Recommended connectorized cable assembly – PN 695-4125-007/013 (26 AWG 5 pair
shielded, jacketed cable). See Figure A-9 for shelf connector location and pinout.
Use repeater cables for cabling repeater shelf 1 to repeater shelf 2 (east-
bound/westbound data/clock).
Table A-3 Fiber Optic Jumpers
PART NO.
3EM07651AA-AK
3EM07646AA-AK
3EM07641AA-AK
Note
Note
APPLICATION
TERMINAL
TERMINAL
REPEATER
A-17