DS1 Repeater Cable Connections
A.2.4.2
The DS1 repeater cable carries clocks, DS1 data, and overhead for two
directions. If the 314 cable is not used, the embedded data in the over-
head must also be cabled individually. In this case, individual cables
must be run for MCS–11, audio, RS-232, and ELMC.
Recommended connectorized cable assembly – PN 695-7836-001/005 (25 pair shielded
cable with 50 pin Amp connectors) (SCSI). See Figure A-7 for shelf connector location and
pinout.
Use repeater cables for cabling repeater shelf 1 to repeater shelf 2 (east-
bound/westbound data/clock)
DS3 LBO CONNECTIONS
A.2.5
The DS3 LBO compensates for the distance to the cross-connect for DS3 and wayside DS1
outputs. See Figure A-8 for connector locations.
Note
Note
A-13