Carton Contents; 6 Miter Handle - Delta MS450 Instruction Manual

1 Work Clamp
2 Extension Bars (2)
3 3mm hex wrench
4 8mm/10mm wrench
5 Thumb screw (2)

6 Miter Handle

7 Thumb Screw for Sliding Fence
8 Sliding Fence
9 Set Screw M6 x 20mm
10 Stop Block
11 Wing Screw / Nuts (3)
12 Clamp Bracket (2)
13 Dust bag
14 Blade Wrench
UNPACKING
1. Carefully remove the machine from the carton. Retain all packing materials until you have inspected and
satisfactorily operated the machine.
DO NOT OPERATE THIS MACHINE UNTIL YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
2. Unassembled items are shown in Fig. 2 for identification and use in assembling the saw.
3. Place the machine on a firm, level surface with extra room for handling and proper support of the workpiece.
4. Familiarize yourself with all features and controls explained in this manual.
5. The machine is shipped with the cuttinghead locked in the down position and the table rotated to 45° left, as shown
in Fig. 3. To release the head and move it to the operating position, see "MOVING CUTTINGHEAD TO THE UP
POSITION" and "MOVING THE TABLE TO THE 0° CUT-OFF POSITION" in this manual (Fig. 5 & 7).

CARTON CONTENTS

Fig. 3
6
7
9
8
14
8
10
4
3
Fig. 2
B
A
Fig. 4
1
5
11
2
12
13