Functional Description; Carton Contents - Delta UNISAW 36-L31 Instruction Manual

10" left tilting arbor saw

Hide thumbs Also See for UNISAW 36-L31:

Instruction manual (76 pages)

Instruction manual (29 pages)

Table Of Contents

Table of Contents

3. Permanently connected machines:

If the machine is intended to be permanently connected, all

wiring must be done by a qualified electrician and conform

to the National Electric Code and all local codes and

ordinances.

* THREE PHASE OPERATION: Three phase machines

are not supplied with a power cord and must be

permanently connected to a building's electrical system.

Extension cords can't be used with a three phase

machine.

* LVC MAGNETIC MOTOR CONTROL: If you

purchased a machine that has a Low Voltage Magnetic

Motor Control System, refer to its instruction manual for

installation guidance.

EXTENSION CORDS

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire

extension cord which has a 3-prong grounding type plug and matching receptacle which will accept the machine's

plug. When using an extension cord, be sure to use one heavy enough to carry the current of the machine. An

undersized cord will cause a drop in line voltage, resulting in loss of power and overheating. Fig. D-1 shows the correct

gauge to use depending on the cord length. If in doubt, use the next heavier gauge. The smaller the gauge number,

the heavier the cord.

FOREWORD

The Delta Unisaw is a 10" left tilting arbor saw. The Delta Unisaw features set the standards in the table saw industry.

A RIP FENCE ASSEMBLY IS NOT PACKAGED WITH THE PRODUCT. YOU MUST INSTALL AND USE A

RIP FENCE SYSTEM FOR RIPPING OPERATIONS.

NOTICE: THE PHOTO ON THE MANUAL COVER ILLUSTRATES THE CURRENT PRODUCTION

MODEL. ALL OTHER ILLUSTRATIONS CONTAINED IN THE MANUAL ARE REPRESENTATIVE ONLY

AND MAY NOT DEPICT THE ACTUAL COLOR, LABELING OR ACCESSORIES AND ARE INTENDED

TO ILLUSTRATE TECHNIQUE ONLY.

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from

all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone,

gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household

floor paste wax.

REMOVE THE STYROFOAM PACKING AND ANY OTHER LOOSE ITEMS FROM THE INSIDE OF THE

SAW CABINET. THE MOTOR COVER MUST BE REMOVED IN ORDER TO REMOVE ITEMS AND PACKING

MATERIAL FROM INSIDE THE SAW CABINET. TO REMOVE THE MOTOR COVER, USE AN ALLEN WRENCH TO

REMOVE THE 1/4-20x5/8" HEX HEAD SCREW FROM LOCATION (B) FIG. 1, AND PUSH MOTOR COVER FIRMLY

TO ONE SIDE TO DEPRESS CLIPS, AND PULL MOTOR COVER OFF. SEE SECTION "MOTOR COVER".

IMPORTANT: The saw is shipped with the saw arbor in the 45 degree position. NOTE: THE HAND WHEEL MUST BE

ASSEMBLED TO THE SAW, SEE THE SECTION "BLADE TILTING HANDWHEEL", THEN PROCEED WITH THE

FOLLOWING. Loosen locking knob on the handwheel, and turn handwheel until the saw arbor is in the 90 degree

position and remove the styrofoam packing from inside the saw cabinet. Tighten locking knob.