Assembly - Delta MS450 Instruction Manual

ASSEMBLY TOOLS REQUIRED
3mm hex wrench (supplied)
ASSEMBLY TIME ESTIMATE
Assembly time for this product will be about 30 minutes to an hour.
MOVING CUTTINGHEAD TO
THE UP POSITION
1. Push down slightly on the cuttinghead (B) Fig. 4
while pulling out the cuttinghead lockpin (A). Move
the cuttinghead (B) to the up position.
2. Fig. 5, illustrates the lockpin (A) pulled out and the
cuttinghead (B) in the up position.
MAKE SURE SAW CUTTINGHEAD
RETURNS FREELY TO THE FULL RAISED POSITION
TO ENSURE THE LOWER BLADE GUARD FULLY
ENCLOSES THE BLADE.
ATTACHING THE MITER HANDLE
Thread the miter saw handle (A) Fig. 5A or (6) Fig. 2
into the hole in the table (B) Fig. 5A.

ASSEMBLY

B
9
A
Fig. 5
B
A
Fig. 5A