Section 1: Safety; Safety Instructions For Power Tools - Grizzly T25227 Owner's Manual

section 1: safety

for your own safety read instruction manual
before operating this power tool
the purpose of safety symbols is to attract your attention to possible hazard-
ous conditions. this manual uses a series of symbols and signal words which
are intended to convey the level of importance of the safety messages. the
progression of symbols is described below. remember that safety messages by
themselves do not eliminate danger and are not a substitute for proper accident
prevention measures.
NOTICE

safety instructions for power tools

oWner's manual. read and under-
stand this owner's manual BEForE using
machine.
trained operators only. untrained
operators have a higher risk of being hurt
or killed. only allow trained/supervised
people to use this power tool. When tool
is not being used, disconnect power, and
store in out-of-reach location to prevent
unauthorized use—especially around chil-
dren. Make workshop kid proof!
dangerous environments. do not
use tools in areas that are wet, cluttered,
or have poor lighting. operating tools in
these areas greatly increases risk of acci-
dents and injury.
-2
-
indicates an imminent hazardous situation which, if
not avoided, Will result in death or serious injury.
indicates a potentially hazardous situation which, if
not avoided, could result in death or serious injury.
indicates a potentially hazardous situation which, if
not avoided, may result in minor or moderate injury.
it may also be used to alert against unsafe practices.
this symbol is used to alert the user to useful infor-
mation about proper operation of the equipment.
mental alertness reQuired. Full
mental alertness is required for safe
operation of power tools. never operate
under the influence of drugs or alcohol,
when tired, or when distracted.
disconnect poWer first. always
disconnect tool from power supply
BEForE making adjustments, chang-
ing tooling, or servicing machine. this
prevents an injury risk from unintended
startup or contact with live electrical
components.
eye protection. always wear anSi-
approved safety glasses or a face shield
when operating or observing machinery
to reduce the risk of eye injury or blind-
ness from flying particles. Everyday eye-
glasses are not approved safety glasses.
T25227 (Mfg. since 09/13)