Cradlepoint MBR1200B Product Manual page 76

MBR1200B| USER MANUAL Firmware ver. 3.6.0
CRADLEPOINT
DHCP Server:
Changing settings for the DHCP server is optional. The
default selections are almost always sufficient.
DHCP Server: (Default: Enabled) When the DHCP server
is enabled, users of your network will be able to
automatically connect to the Internet without any special
configuration. It is recommended that you leave this
enabled. Disabling the DHCP server is only recommended
if you have another DHCP server on your network and it is
configured properly.
Range Start and Range End: These designate the range
of values in the reserved pool of IP addresses for the
DHCP server. Values within this range will be given to any
DHCP enabled computers on your network. The default
values are almost always sufficient (default: 72 to 200, as
in 192.168.0.72 to 192.168.0.200).
Example: The MBR1200B uses an IP address of 192.168.0.1 for its
primary network by default. A computer designated as a Web server has a static IP address of 192.168.0.3. Another computer is designated as an
FTP server with a static IP address of 192.168.0.4. The starting IP address for the DHCP server needs to be 192.168.0.5 or higher.
Lease Time: [Default: 720 minutes (12 hours)] The lease time specifies how long DHCP-enabled computers will wait
before requesting a new DHCP lease. Smaller values are better suited to busy environments.
© 2012 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 74