System Features Learn Routine - Viper 700 ESP Installation Manual

system features learn routine

The System Features Learn Routine dictates how the unit operates. Due to the number of features, they have
been broken up into two menus. It is possible to access and change any of the feature settings using the
Valet /Program switch. However, this process can be greatly simplified by using the optional DEI Bitwriter
®
(P/N 998T) or Personal Computer Interface (P/N 996T). Any of the settings can be changed and then assigned
to a particular transmitter, up to four, a feature called Owner Recognition. Each time that a particular transmit-
ter is used to disarm the system, the assigned feature settings will be recalled. Owner Recognition is only
possible when programming the unit via the 996T or the 998T DEI Bitwriter.
Using the optional DEI Bitwriter or PC Interface, the System Features Learn Routine may be locked. Make sure the
learn routine is unlocked before programming the features. If the siren generates one long chirp when attempting
to program the unit, the learn routine is locked and must be unlocked using the DEI Bitwriter or PC before proceeding.
1. Open a door. (The H1/5 negative door trigger input or the H1/3 positive door trigger input
must be connected.)
2. Turn the ignition on, then back off. (The H2/1 ignition input must be connected.)
3. Select a menu. (See System Features Menus section of this guide.) Press and HOLD the
Valet/Program switch. After three seconds the siren will chirp once indicating entry to the
Basic Features Menu #1. If this is the menu you wish to access, release the switch and go
on to Step 4. If the Valet/Program switch is not released, you will jump to the Advanced
Features Menu #2 and the siren will chirp twice. Once you have selected the desired menu,
release the Valet/Program switch and then go to Step 4.
4. Select a feature. Press and release the Valet/Program switch the number of times corre-
sponding to the feature you wish to change. (See System Features Menus section of this
guide.) For example, to access the third feature, press and release the Valet/Program switch
three times. Then press the it once more and HOLD it. While still holding the switch, the
siren will chirp the number of times corresponding to the feature you have accessed.
5. Program the feature. While still HOLDING the Valet/Program switch, you can toggle the
feature on and off using the remote transmitter. Pressing
(default setting). Pressing
Menus section of this guide.)
© 2000 Directed Electronics, Inc. Vista, CA
will select the two-chirp setting. (See System Features
will select the one-chirp
29