Replacing The Electronics Module - Invacare Pegasus Service Manual

6.17

Replacing the electronics module

CAUTION! If the scooter is supported by the support wheels, it will no longer be braked by
the motor brake. The scooter can roll away out of control.
• Place the scooter rear frame on a piece of supporting wood before removing the wheels.
CAUTION! Burn and scald hazard if power cable is short-circuited!
• Interrupt the power supply by removing the battery plugs before you start work on the
electronic system.
CAUTION: Any modifications made to the drive program can affect the drive behaviour
and tipping stability!
• Changes to the drive program may only be carried out by trained Invacare® specialist dealers!
• Invacare can only provide a guarantee for safe driving - especially tipping stability - for
unmodified standard drive programs.
CAUTION! Accident hazard.
• Secure the scooter against rolling away.
NOTE:
The electronic system is supplied with a standard drive program. If you have carried out
customer-specific modifications to the drive program, you will have to make these changes again
after installing the new electronics module.
NOTE:
When disassembling, note the position of small parts such as screws and washers. Put small
parts down so that they can be reassembled in the right sequence.
NOTE:
The plugs on the electronic module cannot be wrongly connected because all plugs have a
different size and only fit in one socket.
Requirements:
• Open spanner, 10 mm.
•
Open spanner, 17 mm.
•
Rubber hammer
•
Phillips screwdriver
•
Supporting wooden block
•
To adapt the drive program: programming software or hand programming device and
electronics system installation manual, available from Invacare
46
®
.