Central Pneumatic 95119 Set Up And Operating Instructions Manual page 7

6. If necessary, use a torque wrench (not included) to verify the desired torque of
6. If necessary, use a torque wrench (not included) to verify the desired torque of
a bolt/nut. If a bolt/nut requires a higher torque level than that produced by the
a bolt/nut. If a bolt/nut requires a higher torque level than that produced by the
Ratchet Wrench at 90 PSI, an alternate means (other than the Ratchet Wrench)
Ratchet Wrench at 90 PSI, an alternate means (other than the Ratchet Wrench)
of achieving the desired torque should be used.
of achieving the desired torque should be used.
7. When finished, release the Throttle Lever (11) to stop the Ratchet Wrench.
7. When finished, release the Throttle Lever (11) to stop the Ratchet Wrench.
(See Figure C.)
(See Figure C.)
8. Turn off the air compressor. Disconnect the Ratchet Wrench from its air supply
8. Turn off the air compressor. Disconnect the Ratchet Wrench from its air supply
hose, and remove the socket from the tool.
hose, and remove the socket from the tool.
9. Make sure to store the Ratchet Wrench in a dry, clean, location out of reach of
9. Make sure to store the Ratchet Wrench in a dry, clean, location out of reach of
children and other unauthorized users.
children and other unauthorized users.
3/8" DRIVE HEAD
3/8" DRIvE HEAD
INSPECTION, MAINTENANCE, AND CLEANING
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Always make sure the Throttle Lever (11) is in its "OFF"
1. WARNING! Always make sure the Throttle Lever (11) is in its "OFF"
position, and disconnect the Ratchet Wrench from its compressed air supply
position, and disconnect the Ratchet Wrench from its compressed air supply
before performing any inspection, adjustments, maintenance, or cleaning.
before performing any inspection, adjustments, maintenance, or cleaning.
2. Before each use, inspect the general condition of the Ratchet Wrench. Check
2. Before each use, inspect the general condition of the Ratchet Wrench. Check
for loose screws, misalignment or binding of moving parts, cracked or broken
for loose screws, misalignment or binding of moving parts, cracked or broken
parts, damaged air hoses, and any other condition that may affect its safe
parts, damaged air hoses, and any other condition that may affect its safe
operation. If abnormal noise or vibration occurs, have the problem corrected
operation. If abnormal noise or vibration occurs, have the problem corrected
before further use. Do not use damaged equipment.
before further use. Do not use damaged equipment.
SKU 95119 For technical questions, please call 1-800-444-3353
SKU 95119
THROTTLE
THROTTLE
LEVER
LEvER
(11)
(11)
FIGURE C
For technical questions, please call 1-800-444-3353
FORWARD/REvERSE
FORWARD/REVERSE
KNOB (33)
KNOB (33)
AIR
AIR
vALvE
VALVE
CAP (8)
CAP (8)
FIGURE C
PAGE 7
PAGE 7