Table of Contents
Advertisement
3.
Use clean, dry, regulated, compressed air at 90 PSI. Do not exceed the
recommended 90 PSI. Never use oxygen, carbon dioxide, combustible gases, or
any other bottled gas as a power source for this tool.
4.
When connecting to the air supply: Prior to each use, if an automatic oiler is
not used, add two drops of air tool oil (not included) into the Air Inlet (10) fitting of
the Ratchet Wrench.
5.
Always disconnect the Ratchet Wrench from its compressed air supply
source, and squeeze the Throttle Lever (11) to release all compressed air in
the tool before performing any maintenance or services.
Industrial applications must follow OSHA requirements.
6.
WARNING!
7.
chemical known to the State of California to cause birth defects (or other
reproductive harm). (California Health & Safety code 25249.5, et seq.)
8.
WARNING! The warnings, precautions, and instructions discussed in this
manual cannot cover all possible conditions and situations that may occur. The
operator must understand that common sense and caution are factors which can-
not be built into this product, but must be supplied by the operator.
ASSEMBLY AND OPERATING INSTRUCTIONS
following pages, refer to the Assembly Diagram on page 9.
3/8" MINI PALM RATCHET WRENCH
To Attach A Quick Connector:
1.
Prior to use, the Ratchet Wrench requires the attachment of a Quick Connector
(not included) into its Air Inlet (10). To do so, wrap approximately 3" of pipe
thread sealer tape (not included) around the male threads of a Quick Connector.
Then, firmly tighten the Quick Connector into the Air Inlet. (See Figure A.)
FIGURE A
SKU 95119
For technical questions, please call 1-800-444-3353
Due to continuing improvements, actual product may differ slightly from the product described herein.
The brass components of this product contain lead, a
For additional references to the parts listed in the
Model
SET UP AND OPERATING INSTRUCTIONS
Diagrams within this manual may not be drawn proportionally.
Distributed exclusively by Harbor Freight Tools
3491 Mission Oaks Blvd., Camarillo, CA 93011
NOTE:
95119
AIR INLET (10)
QUICK CONNECTOR
.
®
(NOT INCLUDED)
PAGE 5
Advertisement
Table of Contents
