Assembly; Fitting The Hand Guard And Loop Handle; Fitting The Handle; Fitting The Cutting Head - Husqvarna 327HE3X Operator's Manual

Fitting the hand guard and loop
handle
(327HDA65, 327HE3)
1 Assemble the hand guard and loop handle by
screwing them together. Take care to align the holes
in both parts. (327HDA65)
2 Slide the loop handle and hand guard onto the shaft.
(327HDA65)
3 Slide the spacer into the slot in the loop handle.
4 Fit the nut and screw. Do not overtighten.
5 Now make a final adjustment to give yourself a
comfortable working position. Tighten the screw.
CAUTION! The loop handle and hand guard must not
be fitted behind the arrow marked on the shaft.
10 – English

ASSEMBLY

Fitting the handle

(327HE3, 327HE4)
Fit the handle using two screws.

Fitting the cutting head

(327HDA65)
It is important that the hedge trimmer is laid on a flat
surface when you fit the cutting head. Otherwise the
cutting head may not be fitted straight.
1 Fit the cutting head to the shaft. CAUTION! Make sure
the drive shaft inside the shaft engages with the
recess in the cutting head.
2 Tighten the lower screw first, then the upper screw.