ProForm Crosswalk 480 User Manual page 10

8. Have a second person hold a Bolt Spacer (98) in-
side the lower end of the Left Upright (79). Insert
an M10 x 96mm Bolt (7) with an M10 Star Washer
(8) into the Left Upright and the Bolt Spacer.
Repeat this step with a second Bolt Spacer
(98), M10 x 96mm Bolt (7), and M10 Star
Washer (8).
Orient the Left Upright (79) and the Left Upright
Spacer (89) as shown. Hold the Left Upright
Spacer and the Left Upright against the Base
(99). Tighten the M10 x 96mm Bolts (7) until the
heads of the Bolts touch the Upright; do not fully
tighten the Bolts yet.
9. Press a Base Cap (91) into the Base (99).
With the help of a second person, tip the treadmill
so that the Base (99) is flat on the floor.
10. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly.
Identify the Right Handrail (100) which is
marked with a sticker. Hold the Right Handrail
near the console assembly. Attach the console
ground wire to the Right Handrail with a #8 x
1/2" Ground Screw (29).
Next, insert the console wire into the large hole
in the Right Handrail (100) and out of the top as
shown. Attach the Right Handrail with three
M4.2 X 19mm Screws (1). Make sure that no
wires are pinched. Start all three Screws be-
fore tightening any of them; do not over-
tighten the Screws.
Remove the ties from the M8 Cage Nuts (39). If
necessary, press the Cage Nuts back into place.
8
7
8
98
89
99
9
91
99
10
100
39
Console
Ground Wire
Console
Assembly
10
79
1 Console
Wire
1
Large Hole
29
1