Setting Up Ip Addresses For Ds5020 Storage Controllers; Back View; Controllers With Two Standard And Two Optional Fibre Channel Host Expansion Channels; Back View; Controllers With Two Standard Fibre Channel Host Expansion Channels And Two Optional Iscsi Host Expansion Channels - IBM System Storage DS5020 Installation, User's, And Maintenance Manual

Controller A
Figure 3. Back view; controllers with two standard and two optional Fibre Channel host
expansion channels
Controller A
Figure 4. Back view; controllers with two standard Fibre Channel host expansion channels
and two optional iSCSI host expansion channels

Setting up IP addresses for DS5020 storage controllers

After you install DS Storage Manager (as described in the DS Storage Manager
Installation and Support Guide for your host operating system), complete one of the
following procedures to set up IP addresses:
v "Steps for setting up the DHCP/BOOTP server and network"
v "Steps for assigning static TCP/IP addresses to the DS5020 controllers" on page
Steps for setting up the DHCP/BOOTP server and network: To complete this
procedure, you must have the following components:
v A DHCP or BOOTP server
v A network management station (NMS) for Simple Network Management Protocol
v A host that is connected to a storage subsystem through a Fibre Channel I/O
v A management station that is connected by an Ethernet cable to the storage
12
IBM System Storage DS5020 Storage Subsystem: Installation, User's, and Maintenance Guide
Serial Ethernet
port ports
Enclosure ID
Serial Ethernet
port ports
Power-fan
Enclosure ID Fibre Channel
canister
host channels
13
(SNMP) traps
path
subsystem controllers
Dual-ported
Fibre Channel
drive channel
host channels
Dual-ported
Fibre Channel
drive channel
host channels
iSCSI
Dual-ported host Fibre Channel
drive channel
channels host channels
Controller
iSCSI
canister
host
channels
Enclosure ID
Controller B
Ethernet Serial
ports port
Enclosure ID
Controller B
Serial
Dual-ported Ethernet
port
drive
ports
channel