Standard Horizon Eclipse DSC+ GX1100E Owner's Manual page 42

Manual Calling
You may enter an MMSI number manually to contact without the Setting up the
Group call number.
1. Press the [ CALL ( MENU )] key. The "DSC
MENU" will appear.
MENU MENU MENU MENU
2. Press the [ ( UP )] / [ ( DOWN )] keys to se-
GROUP". (To cancel, press the [ 16/9 ]
lect "GROUP
GROUP GROUP
GROUP
key or [ CLR ( WX )] key.)
3. Press the [ ENT ] key. The transceiver will
beep, and the "Group Directory
4. Press the [
MANUAL", then press the [ ENT ] key.
select "MANUAL
MANUAL MANUAL
MANUAL
5. Press the [
through numbers, 0-9. To enter the desired num-
ber and move one space to the right press the
[ ENT ] key. Repeat this procedure until all nine
space of the MMSI number which you want to con-
tact are entered.
6. If a mistake was made entering in the MMSI num-
ber, repeat pressing the microphone's [ H/L ] key
until the wrong nunber is selected, then press the
[ ( UP )] / [ ( DOWN )] keys to correct the entry.
7. When finish the entering the MMSI number, press
and hold the [ ENT ] key.
8. Press the [ ENT ] key, then press the [
[ ( DOWN )] keys to select the operating channel
you want to communicate on and press the [ ENT ]
key.
9. Press the [ ENT ] key again to transmit the Group
Call signal.
10. After the GROUP CALL is transmitted, all the ra-
dios in the group will switch to the channel which
is selected on step 5 above (but, the display will
not change).
11. Press the [ CLR ( WX )] key to return to radio opera-
tion mod.
12. Listen to the channel to make sure it is not busy,
then key the microphone and call the other ves-
sels you desire to communicate with.
Page 42
Group Directory" will appear.
Group Directory Group Directory
Group Directory
( UP )] / [ ( DOWN )] keys to
( UP )] / [ ( DOWN )] keys to scroll
DSC DSC DSC
DSC
( UP )] /
GX1100E