Dsc Transmission Test - Standard Horizon Eclipse DSC+ GX1100E Owner's Manual

9.10 DSC TRANSMISSION TEST

1. Press the [ CALL ( MENU )] key. The "DSC MENU
will appear in the display.
2. Press the [
the "DSC TEST
DSC TEST DSC TEST". DSC TEST
DSC TEST
3. Press the [ ENT ] key, then select the station (name
or MMSI number) to be sent the test signal with
the [ ( UP )] / [ ( DOWN )] keys. This directory uses
the Individual Directory information.
4. If "Manual" is selected at the previous step, enter
the MMSI number (nine digits) which you want to
send the test signal. To do this, press the [ ( UP )]
/ [ ( DOWN )] keys to scroll through numbers "0-
9," then press the [ ENT ] key to move the entry location to the right. If a
mistake was made entering in the MMSI number, repeat pressing the
microphone's [ H/L ] key until the wrong number is selected, then press the
[ ( UP )] / [ ( DOWN )] keys to correct the entry. When finished entering the
MMSI number, press and hold the [ ENT ] key.
5. Press the [ ENT ] key again to transmit the Test sig-
nal.
6. After DSC TEST CALL is transmitted, if the reply
signal is not received, "WAIT FOR ACK
show on the display.
7. When an acknowledgment is received, a ringing
tone sounds and the display shows received data.
8. Press the [ CLR ( WX )] key to return the display to
the radio operation mode display.
GX1100E
( UP )] / [ ( DOWN )] keys to select
WAIT FOR ACK" notition will
WAIT FOR ACK WAIT FOR ACK
WAIT FOR ACK
DSC MENU DSC MENU" DSC MENU
DSC MENU
Page 51