COMMAND QUICK REFERENCE
This section lists all software commands of the printer. For more information please refer to
the Programmer's Manual.
Command Set for PPLA
The following commands are for Printer Programming Language A.
Note: In this quick reference all variable data is represented in Italics.
System Setting Commands
These commands will cause the related parameters to be saved in the non-volatile memory,
E2PROM. The parameters will be stored unless they are changed by another command,
or reset from the panel.
Command
<STX>KI4n
<STX>KI7n
<STX>KI8n
<STX>KI;n
<STX>KXnnnn
<STX>KI<m
Description
Media empty check
Set ribbon mode
Set baud rate
Control Code types
Set continuous label
length
Set symbol set for ASD
smooth font set
Parameter
n : '0' - disable,
'1' - enable.
n : '0' – DT,
'1' – TT.
n : '0' – 9600,
'1' – 600,
'2' – 2400,
'3' – 19200,
'4' – 4800,
'5' – 38400,
'6' – 1200,
'7' – 9600.
n : '0' - selects standard control
codes.
'1' - Select alternate control
codes
nnnn : a 4-digit number, in mm
m : '0' - USASCII,
'1' - United Kingdom,
'2' - Spanish,
'3' - Swedish,
'4' - French,
'5' - German,
'6' - Italian,
'7' - Danish/Norwegian.
Factory default
Enabled
TT with ribbon
(for FM4402)
9600 baud.
(for FM4402)
For FM4402
0 for USASCII
User's Guide
49