15. Grasping the Sensor Adjust Knob and sliding in or out as needed can move the Media
Sensor. This is required only if the sensor must be moved to a specific location on the
label to detect a notch (hole) or gap.
16. Important: To ensure proper media feeding and sensor operation, complete the following
checklist:
Media is wound Face Out (print side out) and feeding off the top of the roll.
q
Media is routed exactly as shown over the Back Media Rail and under the
q
Front Media Rail.
Media is routed between the Upper and Lower Media Sensor Arms located
q
under print module.
The green Outside Media Guide has been re-installed.
q
If required, the media sensor is adjusted directly over the notch (hole) or gap.
q
22
User's Guide
Figure 16 - Media Sensor Adjust Knob