Procedure To Enter Into Set-Up Mode; Figure 24 - Entering Into Set-Up Mode - AMT Datasouth Fastmark 4000 Series User Manual

Procedure to Enter into Set-up Mode

FM 4602 and FM 4603 models only
1. Power on the printer.
When the " READY" message is displayed on the LCD, press [PAUSE] and
2.
the [CANCEL] buttons simultaneously.
3. Press [PAUSE] button to scroll to the feature that you want to change.
4. Press [FEED] button to scroll to the desired value of the displayed feature.
5. Once the desired value is displayed, press [CANCEL] button to save it. After
pressing the [CANCEL] button an * should appear in the last column. The * is
used to designate the stored value in non-volatile memory (E2PROM).
6. Press both [PAUSE] + [CANCEL] buttons at the same time, to return to
normal mode.
Note: Do not enter set-up mode while the printer is printing or while the host is
sending data.
40 User's Guide
Press to Enter / Exit Setup Mode

Figure 24 - Entering into Set-up Mode

Next Value
Next Feature
Enter Value