Www.desatech.com - Desa CD36RN Owner's Operation And Installation Manual

NOTICE: During initial operation
of a new heater, the burning of
residues from the manufacturing
process of the firebox and logs
will produce a paper-burning
smell and orange flames. Open
a window for the first few hours
of operation to adequately vent
this smell.
TO TURN OFF GAS
TO AppLIANCE
1. Turn off wall switch.
2. Turn off all electric power to appliance if
service is to be performed.
3. Open lower louver panel.
4. Turn equipment shutoff valve clockwise
to OFF. Do not force.
5. Close lower louver panel.
OpTIONAL WIRELESS
REMOTE OpERATION
Note: The WRC receiver and hand-held
remote control kit must be purchased sepa-
rately (see Accessories, page 52). Follow
installation instructions included with the
remote control.
1. Turn equipment shutoff valve to ON posi-
tion. You can now turn burner on and off
with the-held remote unit.
IMPORTANT: Be sure to press the ON/
OFF buttons on hand-held remote control
unit for up to 3 seconds to assure proper
operation.
2. Press the ON/OFF button to turn burner
on and off.
IMPORTANT: Do not leave selector switch
in the REMOTE or ON position when the
pilot is not lit. This will drain the battery.
Figure 67 - Setting the Selector Switch, Gas
Control Knob and Variable Control Knob for
Remote Operation
36
OPERATION
ELECTRONIC IGNITION MODELS
OFF
ON

www.desatech.com

Continued
OpERATING OpTIONAL
GWMT1 - WALL MOUNTED
THERMOSTAT
WARNING: Do not con-
nect the thermostat to a power
source. Electrical shock and/or
a fire hazard will occur.
Light the fireplace as instructed in Lighting
Instructions on page 35. Set wall thermostat
to desired temperature.
This thermostat has been electronically cali-
brated at the factory and requires no adjust-
ment or leveling.
Upon installation, thermostat must be allowed
to stabilize at room temperature for a mini-
mum of 30 minutes for proper operation.
To turn fireplace off, adjust thermostat to the
lowest setting and turn gas control knob back
to PILOT. The pilot will remain lit.
IMPORTANT: To turn pilot off, turn gas control
knob on heater to the OFF position.
OpERATING OpTIONAL
BLOWER ACCESSORy
Locate blower controls by opening lower
louver panel on fireplace. Blower controls are
located on the right side of switch bracket to
the left just inside louver panel.
The BK manual blower and BKT thermostati-
cally-controlled blower have an ON setting
and an OFF setting. The blower will only run
when switch is in the ON position. In the OFF
position, blower will not operate.
Note for BKT Only: If you are using BKT
blower with optional thermostat (wall mounted
or remote control) for the fireplace, your fire-
place and blower will not turn on and off at the
same time. The fireplace may run for several
minutes before blower turns on. After heater
modulates to the pilot position, the blower will
continue to run. The blower will shut off after
the firebox temperature decreases.
The blower helps distribute heated air from the
fireplace. Periodically check louvers of firebox
and remove any dust, dirt or other obstruc-
tions that will hinder the flow of air.
116035-01J