Table of Contents
Advertisement
-- Notes on Movie Shooting
Recording and Image Quality
elf the attached lens has an Image Stabilizer, the Image Stabilizer will
operate at all times even ify6u do not press theshutterbutton halfway.
The Image Stabilizer may cause the total movie shooting time or the
number of possible shots to decrease. If you use a tripod or if the Image
Stabilizer is not necessary, you should set the IS switch to
<OFF>.
• The camera's built-in microphone will also pick up camera operation
noise. If you use a commercially-available external microphone, you can
prevent (or reduce) these noises from being recorded.
• Do not connect the external microphone IN terminal to anything other
than an external microphone.
• Autofocusing during movie shooting is not recommended since it might
momentarily throw the focus way off or change the exposure. Even if the
AF mode has been set to [Quick mode], it will switch to the Live mode
during movie shooting.
s If movie shooting is not possible due to the insufficient remaining
capacity of the card,. the movie shooting remaining time (p.152) will be
displayed in red.
elf you use a card having a slow writing speed, a five-level
indicator might appear on the right of the screen during
movie shooting. ltindicates how much data has not yet been
written to the card (remaining capacity ofthe internal buffer
memory). The slower the card, the faster the indicator will
climb upward. If the indicator becomes full, movie shooting
will stop automatically.
Indicator
If the card has
a
fast writing speed, theindicator will either
not appear or the level (if di$played) will hardly
90
upw~rd.
First, shoola few test movie's to see ifthe card can write fast
enough~
If you take still photos during the movie shooting, the movie shooting
might stop. If the still image recording quality has been set low, the movie
shooting might continue instead.
eWhenmovieshootiriglsset,certainCusfom.Function• • settings ·will·be
disabled (p.205).
158
Advertisement
Table of Contents
