Asus UP-895MD Series User Manual page 131

DirectKey (DRCT) [Enabled]
[Disabled] Disables the DirectKey button. The system will only power on or off when
you press the DirectKey button.
[Enabled] Allows the system to power on and go to the BIOS Setup directly when you
press the Reset button. Connect the 2-pin connector of the chassis reset
buton cable to the onboard DRCT header.
Boot Logo Display [Auto]
[Auto] Sets the boot logo to display during POST.
[Full Screen] Sets the boot logo display in full screen during POST.
[Disabled] Disables the boot logo display during POST.
The following item appears only when you set the Boot Logo Display to [Auto] and [Full
Screen].
Post Delay Time [3 sec]
This item allows you to select a desired additional POST waiting time to easily enter
the BIOS Setup. You can only execute the POST delay time during normal boot. The
values range from 0 to 10 seconds.
This feature only works when set under normal boot.
The following items appear only when you set the Boot Logo Display to [Disabled].
Post Report [5 sec]
This item allows you to select a desired POST report waiting time.
Configuration options: [1 sec] - [10 sec] [Until Press ESC]
Bootup NumLock State [Enabled]
This item allows you to enable or disable power-on state of the NumLock.
Configuration options: [Disabled] [Enabled]
Wait For 'F1' If Error [Enabled]
This item allows your system to wait for the <F1> key to be pressed when error occurs.
Configuration options: [Disabled] [Enabled]
Option ROM Messages [Enabled]
[Enabled] The third-party ROM messages will be displayed during POST.
[Disabled] Disables the ROM messages and displays only the ASUS logo during
POST.
Interrupt 19 Capture [Disabled]
This item allows you to trap Interrupt 19 by the option ROMs.
Configuration options: [Disabled] [Enabled]
ASUS Z97-PRO Series
3-53