Alto LYNX-MIX124 USB User Manual page 18

4. CONTROL ELEMENTS
45 PHONES Jacks
These jacks will be used to send the signal to a pair of
headphone or to powered studio monitors.
46 LAMP socket
This lovable LAMP is very convenient for your operati-
on, it is located in the top right corner of the front
panel, and provides the 12V socket that can drive
standard BNC-type lamp.
REAR PANEL
51 52 54
47 48
53 59
MAIN MIX OUTPUT (BAL/UNBAL) USB
POWER PHANTOM
ON +4dBu
-30dBu
SUB
1/2
L
MAIN
RECORD
OUTPUT
LEVEL
OFF
MAIN INSERT MONO
0
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
DESIGNED IN ITALY
L L
- +15
R R R
AC INPUT
Use only with a 250V fuse
100-240V 50/60Hz
Fuse: T1.6AL
TIP SEND
RATED POWER
(BAL/UNBAL)
RING RETURN
CONSUMPTION: 70W
56
50
55 57
49
47 POWER Switch
This switch is used to turn the main power on and off.
48 +48 Volt Phantom Power
It is available only to the XLR MIC sockets. Never plug in a microphone when
phantom power is already on. Before turning phantom power on, make sure
that all faders are totally down. In this way, you will protect your stage
monitors and main loudspeakers.
49 AC Inlet with FUSE Holder
Use it to connect your L YNX-MIX USB mixer to the main AC with the supplied
AC cord. Please check the voltage available in your country and how the
voltage for your L YNX-MIX USB mixer is configured before attempting to
connect your L YNX-MIX USB mixer to the main AC.
16
61
AUX SENDS DIRECT OUTS (BAL/UNBAL)
CH16 CH15 CH14
1 2 3 4
MAIN CH MAIN
MIX. 23/24 MIX.
PLAY BACK
AUX RETURNS SUBGROUPS OUT
CTRL OUT DFX OUT
1 2 3 4 1 2 3
L L L L L
R R R R R
1 2 3
FOOT SWITCH SUBGROUPS INSERT
58
60 62
65
63
DIRECT OUTS (BAL/UNBAL)
CH13 CH12 CH11 CH10 CH9
4
4
64
46
45
DIRECT OUTS (BAL/UNBAL) DIRECT OUTS (BAL/UNBAL)
CH8 CH7 CH6 CH5 CH4 CH3 CH2 CH1