Alto LYNX-MIX124 USB User Manual page 15

4. CONTROL ELEMENTS
27 SUB1-2/SUB3-4/MAIN MIX Buttons
These three buttons are configured for AUX RETURN4, they can be regarded
as the signal assignment switches. When engaging the SUB1-2, the stereo
signal from AUX RETURN4 will be assigned to Subgroup1/2; in the same way,
SUB3-4 for Subgroup3/4, MAIN MIX for MAIN MIX buses.
28 AUX RETURNS SOLO Button
The function of AUX RETURN SOLO is like the channel SOLO button. Engaging
it sends the signal from AUX RETURN (1-4) to the CTRL OUT, PHONES outputs
and Meters display. It can also be affected by SOLO mode button, and the LED
next to the button will illuminate.
29 SUBGROUPS ASSIGN TO MAIN MIX
Through these switches, you can operate the subgroup faders as a master
control for assigning the subgroups to MAIN MIX. Engage the LEFT switch to
send the corresponding subgroup signal to MAIN MIX L, and the RIGHT
switch for MAIN MIX R. When engaging the both switches, the signal will be
sent to L/R of MAIN MIX.
30 SUBGROUPS Fader
These faders are used to control the levels of the signal send to the SUB-
GROUPS OUT, the adjustable range goes from -
that is assigned to the subgroups, not muted and not turned down will be
assigned to the SUB OUTS.
31 MAIN MIX LEVEL Fader
This fader sets the amount of signal send either to the Main Mix Output or
to the Tape Output.
32 LED Meter
The stereo 12-segment LED Meter will indicate the signal level send to the
Ctrl Room and Phones outputs.
33 2TK TO MIX Button
Engaging this switch allows you to combine the 2-Track output with the Main
Mix. In other words, feeds the 2-Track In signals into Main L/R output.
34 SOLO MODE Button
This button provides two modes: up for PFL (Pre-Fader-Listen) mode, down
for AFL (After-Fader-Listen) mode. Engage the button, the soloed signal will
output after the Level control, otherwise, release the button will output the
to +10 dB. Any channel
13