Alto LYNX-MIX124 USB User Manual page 19

4. CONTROL ELEMENTS
50 MAIN MIX OUTPUT
These stereo outputs are supplied with both the XLR and 1/4" phone jacks
and it is controlled by the Main Mix Level.
51 MAIN OUTPUT LEVEL Button
This button sets the main mix output level to match the input of the device
that you are ready to connect. Engage this button to reduce the output
level from MAIN MIX OUTPUT by 30 dBu, it is used to match the semipro -30
dBu device, on the contrary, to match the professional +4 dBu device.
52 USB PORT
This USB port is used to connect the unit to PC with a transmission line.
When it is in output mode, it can connect with the SUB1-2 or MAIN MIX
output; in the input mode, it can connect with the CH11/12 (for L YNX-MIX
124 USB, CH15/16 for L YNX-MIX164 USB, CH19/20 for L YNX-MIX204 USB,
CH23/24 for L YNX-MIX244 USB) or MAIN MIX output.
53 USB RECORD Switch
You can select SUB1/2 or MAIN MIX track to input the record signal to PC.
54 USB PLAYBACK Switch
You can select CH11/12 (CH15/16 for L YNX-MIX164 USB, CH19/20 FOR
L YNX-MIX204 USB,
output the audio signal from PC.
55 MAIN INSERT
These two 1/4" phone jacks are stereo insert points and used to connect
processors such as compressors, equalisers etc.. When insert a external
processor into the jack, the Main stereo signal will be taken out after the
EQ and returned into the MAIN MIX output before the MAIN MIX fader.
56 MONO Level Control
This knob sets the level of mono mix output signal, which can be varied from
- to +15 dB.
57 MONO OUTPUT Jack
This 1/4" phone jack is balanced/unbalanced mono mix output connector, it
can be regarded as a sum output of the left and right of MAIN MIX.
58 CTRL OUT Jacks
These 1/4" phone jacks will be used to send the Control Room signal to the
studio monitor speakers or a second set of PA.
CH23/24 for L YNX-MIX244 USB ) or MAIN MIX track to
17