Pulse GSM Gateway Operation Manual page 19

Q7: how many allow-to-dial codes can this machine memorize？
A : 50 sets.
Q8: Can we use to fax or make data preparation？
A : Negative, only can perform tone function exclusively.
Q9: After setting up allow-to-dial code, why we can't select the allow-to-dial route?
A : (1) Check if line (PSTN) is connected properly.
(2) The allow-to-dial function hasn't been set up yet, i.e., not to follow the correct setup
procedure processing setup.
(3) This machine derives the line malfunction inspecting ability. If the line is out of
order, it will connect to GSM route in a forced way (have to set up local code in
advance).
Q10: If the has no power on it, and its line connects to PSTN, can it dial out?
A : Yes, it could, yet is confined to dial out by PSTN only.
Q11: Can the phone make inspection on the echo signal of polarity reversal?
A : Yes, it could. When call is dialed out through GSM, the phone will make linear
polarity reversal when it's called for echo response.
Q12: Does the machine deserve CLID function?
A : Yes, it does. When GSM sends in call signal, it will send the CLID out from phone by
DTMF signal.
Q13: How to compulsorily dial out any number through GSM (VPN)?
A : We can press '*' before dialing out, and dial phone number next to it. Finally, press '#'
to finish this task.
Operation Manual 17