Short Code Setting - Pulse GSM Gateway Operation Manual

Operation Manual 14
Default password : no password
(3.3)Password prompt tone setup
Format : *#** (Waiting for confirming tone)
84 is the function code, bb should be the same as aa
aa=11 (* TONE)，12(# TONE), 13(A TONE)，14(B TONE)，5(C TONE)，00(D
TONE)，16 No tone
Default value : 15 (C Tone)
▓Remarks
Interpretation of echo-sound
[Command confirmed]: two beeps
[Setting is correct]: single beep
[Setting is error]: four consecutive beeps.

12. Short Code Setting

Allow to setup 100 sets of short code. Once the short code has been set (see function 31
below), user may press 00# ~ 99# for fast dialing. (*0# ~ *9# are also accepted and regards
as *00# ~ *09#). The routing function applies to the setup number rather than the short
code itself.
To enable/disable the short code function :
Format : *#** (wait for confirming tone)
30aabb#
aa : 01 for disable short code function
02 for enable short code function
99 clear all the numbers associated with the short codes
bb : should be the same as aa
To set the number for short code :
Format : *#** (wait for confirming tone)
password authentication. Entering password has to be done in 30
seconds. If no password is required, press *#**83**#
84aabb#