1.
Pull the main fi lter (outer) fi lter out.
2.
Remove the inner fi lter.
3.
Clean inside the fi lter housing, cover
housing and dust cap. Wipe dry only.
4.
Reinstall or replace the inner fi lter with the
open end fi rst, ensuring that it enters the
housing recess. Push in to the end.
5.
Reinstall or replace the outer fi lter with the
open end fi rst so that it enters the recess.
Push in to the end.
6.
Replace the end cover with the rubber valve
pointing downwards and secure retaining
clips.
IMPORTANT INFORMATION
The end cover must be installed with the
rubber valve pointing downwards or the
rubber valve will not function.
Engine Oil Cooler
Clean the outside of fi ns with a brush.
Remove the two screws holding the cooler unit to the
blower housing.
Tilt the cooler downward.
Clean the inside of the cooler with a brush or with
compressed air.
Reinstall the oil cooler to the blower housing
MAINTENANCE
Removing the main fi lter
Removing the inner fi lter
Engine oil cooler
8011-449
8011-450
8011-472
43
-
English