Table of Contents
Advertisement
$
I/F BUFFER
Buffer size in Kbyte. The maximum (factory setting) size is 64 Kbyte.
$
DSR/CTS MODE (Only indicated if the serial interface is selected)
Selectable are: IGNORE DSR+CTS, DSR+CTS ACTIVE, CTS ACTIVE,
or DSR ACTIVE.
$
CUT DEVICE
The Cut Device is an option. The standard setting is NO. To activate the Cut
Device set this parameter to YES.
$
CUT. V-POS LO. / CUT. V-POS UP. (only displayed if Cut Device = YES)
(Vertical adjustment of cut position)
This can be set differently for each paper source (lower and upper tractor)
and is meant to be a corrective parameter to meet variations in paper size
and pre-printed material.
The parameter covers a range of - / " to + / " of an inch, where "-" is up
the page and "+" is further down the page. The default value is zero.
If, for some reason, it is not desired to cut exactly on the perforation it is
Note:
very important to cut below the perforation of the printed page. If the
paper is cut above the perforation the remaining paper can easily bend
and cause a paper jam. Do not cut through a label as the blade would
get dirty by the glue.
The following table shows the possible values in inch and millimetres.
1
+/- 1
= +/- / " = +/- 0,42 mm
60
2
+/- 2
= +/- / " = +/- 0,85 mm
60
3
+/- 3
= +/- / " = +/- 1,27 mm
60
4
+/- 4
= +/- / " = +/- 1,69 mm
60
A higher value shift the paper up and such the cut position further down the
page. When you reduce the value the cut position is moved up the page.
Description of the Individual Menu Items
8
8
60
60
+/- 5
= +/- / " = +/- 2,12 mm
+/- 6
= +/- / " = +/- 2,54 mm
+/- 7
= +/- / " = +/- 2,96 mm
+/- 8
= +/- / " = +/- 3,39 mm
5
60
6
60
7
60
8
60
4-11
Advertisement
Table of Contents
