Ariens Zoom XL 915111 Owner's/Operator's Manual page 13

• Left (3) – Pull left steering lever back or
push right steering lever forward or a
combination of both.
• Right (4) – Pull right steering lever back
or push left steering lever forward or a
combination of both.
1
3
NOTE: To stop, return both steering levers to
neutral.
NOTE: The steering levers must be in the
neutral position to start the engine.
NOTE: The parking brake must be
disengaged prior to moving the steering
levers from the neutral position.
Mower Lift Pedal (figure 5)
Raises and lowers the deck.
1
1. Adjustment Pin
2. Mower Lift Pedal
3. Adjustment Hole
NOTE: The adjustment pin is used to set the
height of the mower deck. See
SPECIFICATIONS on page 27 for cutting
height dimensions.
Press mower lift pedal and install adjustment
pin in the desired adjustment hole.
2
3
Figure 5
shipped with the front axle in the lockout
position.
If a pivoting front axle is needed: Remove
2
axle lock hardware from lockout position and
install axle lock hardware in pivoting position
on both sides of front axle.
NOTE: To lock front axle, install axle lock
hardware in the lockout position on both sides
of the axle.
4
Adjusting Seat
Lift adjustment lever and slide seat forward or
backward to the desired position.
1
FILLING FUEL TANKS
1. Clean fuel caps and surrounding area to
prevent dust, dirt, and debris from
entering fuel tanks.
2. Remove fuel caps.
IMPORTANT: See Engine Manual for correct
type and grade of fuel.
3. Fill fuel tanks to 2-1/2 in. (6.35 cm)
below bottom of filler neck. See
SPECIFICATIONS on page 27 for
capacity of fuel tanks.
4. Replace fuel caps.
STOPPING IN AN EMERGENCY
Bring steering levers back to neutral, set
parking brake, and turn off engine.
GB - 13
NOTE: Adjusting the seat
further forward will help
increase the leverage in
lifting the mower deck (see
FILLING FUEL TANKS on
page 13).
NOTE: The unit comes
1. Seat
2. Adjustment Lever
Figure 6
2