Powering On The Switch - HP 7500 Series Installation Manual

6. On the Settings tab, set the emulation to VT100 and click OK.
Figure 43 Setting terminal emulation in Switch Properties dialog box

Powering on the switch

Before powering on the switch, confirm the following:
• You know where the power switch of the equipment room is located.
The switch has been steadily mounted.
•
All the cards have been correctly installed.
•
All the communication cables, fibers, power cords, and grounding cables have been correctly
•
connected.
The voltage of power supply can meet the requirements of the switch.
•
• The console cable has been correctly connected. The configuration terminal has been started, and
the terminal parameters have been configured.
To power on the switch:
Turn on the power source of the switch to power on the switch.
The following is a sample output you can see on the terminal:
Starting......
RAMLine.....OK
System is booting................
************************************************************************
*
49
*