HP ProCurve Series 2810 Management And Configuration Manual page 83

Figure 4-1. Example Listing of IGMP Configuration for All VLANs in the Switch
Viewing the Current IGMP Configuration. This command lists the IGMP
configuration for all VLANs configured on the switch or for a specific VLAN.
Syntax: show ip igmp config
IGMP configuration for all VLANs on the switch.
Syntax: show ip igmp < vid > config
IGMP configuration for a specific VLAN on the switch, including
per-port data
Syntax: show ip igmp group < ip-address >
Lists the ports on which the specified multicast group IP address
is registered.
(For IGMP operating status, see the appendix on monitoring and analyzing
switch operation in the Management and Configuration Guide.)
For example, suppose you have the following VLAN and IGMP configurations
on the switch:
VLAN ID VLAN Name
1 DEFAULT_VLAN
22 VLAN-2
33 VLAN-3
You could use the CLI to display this data as follows:
The following version of the show ip igmp command includes the VLAN ID (
designation, and combines the above data with the IGMP per-port
configuration:
Multimedia Traffic Control with IP Multicast (IGMP)
CLI: Configuring and Displaying IGMP
IGMP Forward with
Enabled High Priority
Yes No
Yes Yes
No No
Querier
No
Yes
No
vid)
4-7