Clearray™ Lamp Replacement And Quartz Tube Maintenance - Sundance Spas 680 Series Owner's Manual

After a year the lamp must be replaced. If the UV timer has been
programmed correctly a message will appear on the LED display when
the time allotted has expired. In order to clear the "blb" message a new
UV lamp needs to be installed and the timer must be reset (Section 10.9,
page 34).
Note: In order to access the CLEARRAY unit, the front synthetic panel or
the stereo panel and the right corner panel need to be removed.
12.4 CLEARRAY™ Lamp Replacement and Quartz Tube
Maintenance
Important: It is MANDATORY that the UV lamp is replaced and the
quartz tube be cleaned every 12 months to maintain optimum
performance.
1
DANGER:
!
POSITION!
WARNING:
!
REMOVING FROM QUARTZ TUBE.
DANGER:
!
CAUSE SEVERE EYE DAMAGE OR BLINDNESS.
UV lamp replacement and quartz tube maintenance:
Note: Location of CLEARRAY System and connection
may vary by model.
1. Turn the breaker to the spa OFF. We recommend
that you drain your spa. Disconnect the
CLEARRAY System from the controller, Figure 2.
2. Once the UV lamp has cooled off remove the
CLEARRAY System enclosure cover (10) and
gasket (9) by removing the four screws (11).
4
2
5
3
13
12
TURN THE SPA BREAKER TO THE OFF
ALLOW LAMP TO COOL DOWN PRIOR TO
NEVER LOOK AT THE LIT BULB. THIS CAN
9
8
6 7
680 SERIES
10
11
Figure 1
UV Unit
WARNING!
DO NOT LOOK AT LIT BULB
SEVERE EYE DAMAGE
OR BLINDNESS CAN OCCUR
SPA CONTROLLER
Connection
Figure 2
Page 43