Pillow Care (All Models Except Denali); Cleaning The Spa Interior - Sundance Spas 680 Series Owner's Manual

680 SERIES
CAUTION! READ THIS BEFORE DRAINING: To prevent
!
damage to the spa's components, turn off power to the
spa at the circuit breaker before draining it. Do not turn
the power back on until your spa has been refilled. There are
certain precautions to keep in mind when draining your spa.
If it is extremely cold, and the spa is outdoors, freezing could
occur in the lines or the equipment (see "WINTERIZING",
page 40). On the other hand, if it is hot outdoors, do not
leave the spa's surface exposed to direct sunlight.
To drain your spa, perform the following steps (actual
drain may vary from one shown). Turn off power
to spa at breaker.
1. Locate and remove the synthetic cabinet door
screws and door. The door is located directly
below the control panel and is easily identified by
it's vertical cooling slots.
2. Locate drain hose line attached to 2 x 4 wood slat
(Figure A) with tie wraps.
3. Cut tie wraps and pull drain hose from equipment
area (Figure B).
4. Hold drain hose above water line, then unthread
drain cap (1) from hose using a counterclockwise
rotation (Figure B). Place hose on ground making
sure to direct water away from spa. If equipped,
turn valve (2) counterclockwise to open the valve
(Figure C).
5. After spa has completely drained, reinstall
drain cap on drain valve finger tight! DO NOT
OVERTIGHTEN! If equipped turn valve (2)
clockwise to close the valve.
6. Place drain hose back inside the spa equipment bay.
7. Reinstall synthetic cabinet door and screws.
8. After refilling spa, turn on power and follow the "Spa Fill Up
Procedure" (page 18).
11.3

Pillow Care (All Models Except Denali)

Remove and clean the headrest pillows as needed with soapy water using
a cloth or soft-bristle brush. To maintain water resistance and luster, apply
a quality vinyl conditioner once a month. Always remove the pillows when
adding chemical shock treatment to the spa water. The pillows can be
returned to the spa when the sanitizer reading is stable as recommended
on the inside cover of the manual.
11.4

Cleaning The Spa Interior

To preserve the sheen of your spa's surface, it is crucial that you avoid
using abrasive cleaners or cleaners which have adverse chemical effect
Page 38
Figure A
2
1
Figure B
Figure C