Toshiba RAV-SP1104AT8-E Service Manual page 124

No. Part name
1. Detachment
Noise filter
7
board
1) Perform the operation in 1. of
MCC-1600
2) Remove the screws (3 positions) fixing the inverter assem-
3) Remove the lead wires connector to other components from
4) Remove the claw of the support (2 positions) and the screw
2. Attachment
1) Mount noise filter board.
2) Mount components in the opposite method to that when
Using the hook,
it is possible to temporarily suspend
the inverter assembly (front).
Procedure
U V
1.-2 of and 1.-2 of .
bly (front). Then slide the inverter assembly (front) upwardly
and remove.
the noise filter board.
CN05: Power supply terminal block (red)
CN06: Power supply terminal block (White)
CN07: Power supply terminal block (Black)
CN08: Power supply terminal block (Gray)
CN09: Connection to earth (Brown)
CN10: Posister (Red)
CN16: Relay (Red)
CN17: Compressor IPDU board (White)
CN18: Relay (Black)
CN19: Relay (Gray)
CN20: Power supply terminal block (White)
CN23: Fan-IPDU board (5P, Red)
CN50: Interface board (2P, White)
CN51: Fan-IPDU board (2P , Back)
Connectors should be removed after unlocking the
housing section.
(2 positions) fixing the base and then remove the noise filter
base.
removing.
Q T
,1. of ,
Using
– 124 –
Remarks
Fan-IPDU boardg
Interface board
Inverter assembly (front)
Screws
(2 positions)
Noize filter board
State of noize State of noize
filter board filter board
when removed when removed