Electrolux T5675 Service Manual page 37

Motor
37
In order to loosen the belt, first loosen the four screws a bit.
47
1 2 3 4
fig.490377800
Loosen the belt (C) from the "motor arm".
Demount the motor pulley (D) by loosening the screw (2).
48
fig.7224C
Mount the new motor pulley and put the belt in position (C) and tighten the screws. Start by
tightening 1 and 3 a bit. Thighten 4 and check the belt tension with a frequency meater or similar.
The frequency shall be 80 Hz ± 5. Adjust with 4 if necessary. Then tighten 2 with tightening
torque 80 Nm ± 5 and finally 1 and 3 with tightening torque 6 Nm ± 1 again when all is in position.
Check that 5 is tightened.
49
1 2 3 4
5
fig.490377800A