Troubleshooting
132
12:12 DRYING ERROR WITH AUTOSTOP PROGRAM
The error code is shown if the analog input OULET AIR TEMP (NTC) does not register the STOP
VALUE FOR AUTOSTOP PROGRAM reached within the maximum drying time (normally 90
minutes).
When the error is trigged the machine will automatically go to the cooling module before the
program ends.
The error code is reset from the control system by a short press on the control knob/start button.
A long press on the control knob/start button will make the control system reset and ongoing
program will be ended.
If the clothes are still wet after maximum drying time and the dryer is not overloaded, check that the
heating system is working correct by using the ACTIVATE OUTPUTS menu when the machine is
in service mode.
Note!
Make sure that the fan is active before turning on the heat.
If the clothes are dry, check the outlet air sensor and harness, connectors and functions by reading
the electrical schematic and by using the SHOW INPUTS menu when the machine is in service mode.
12:13 DRYING ERROR WITH TIME PROGRAM
The error code is shown if a time program has continued longer than the maximum drying time
(normally 90 minutes) without the door has been opened.
When the error is trigged the machine will automatically go to the cooling module before the
program ends.
The error code is reset from the control system by a short press on the control knob/start button.
A long press on the control knob/start button will make the control system reset and ongoing
program will be ended.