Electrolux T5675 Service Manual page 136

136
13:8 DOOR UNLOCKING
The error code is shown if unbalance switch is active at program start.
Recommended actions:
1. Check unbalance switch for proper alignment..
2. Check unbalance switch for electrical fault.
13:9 WATER IN DRUM - CALL SERVICE
This error code will be shown if the control system detects water above safety level when program
is finished. Possibly caused by broken inlet valve and / or drain valve.
Recommended actions:
1. Turn off water inlet to machine.
2. Manually open the drain valve.
3. Check reason for valve malfunction.
13:10 WATER IN DRUM - CALL SERVICE
This error code will be shown if the control system detects water above safety level in idle mode.
Possibly caused by broken inlet valve and / or drain valve.
Recommended actions:
1. Turn off water inlet to machine.
2. Manually open the drain valve.
3. Check reason for valve malfunction.
13:11 UNLOADING DOOR NOT LOCKED
This error code will be shown if the control system detects that the input DOOR LOCKED 2 has not
been activated within a certain time after unloading door is closed.
It will also be activated if the input DOOR LOCKED 2 has been deactivated during an on-going
program.
Possible causes:
This can be caused by a mechanical problem preventing door lock to lock, defective door lock,
loose cable connection to door lock, broken cables to door lock or mechanical problem with
emergency opening of the door.
Recommended actions:
1. Check door lock functionality in service program, by activating door lock and then by checking
check inputs.
2. Check electrical connections by reading inputs at the same time as cables carefully
moved/pulled.
3. Carefully knock on the door lock unit to locate intermittent errors.
Troubleshooting