Installation And Setup; Installation; Unpacking The Unit; Standalone Modem Installation - Canoga Perkins 2240 User Manual

2. Installation and Setup

2.1 Installation

Installation for the 2240 Fiber Optic Modem includes unpacking the unit, and
considerations for installing the standalone and rackmount models.

2.1.1 Unpacking the Unit

Each 2240 Modem is shipped factory tested, and packed in protective cartons.
Unpack the unit and retain the shipping carton and protective packing for reuse in
the event a need arises for returning it to the factory.
To assure proper operation of the modem, please inspect it and its shipping carton
carefully for damage. If damage is sustained to the unit, file a liability claim
immediately with the freight carrier.
2.1.2 Standalone Modem Installati
Installing the standalone version of the 2240 Modem is relatively straightforward.
It should be located conveniently to the operator and the electrical and optical
cables. Fiber optics cables should be isolated from foot traffic to prevent possible
damage.
The standalone power supply, which is attached to the unit, is a wall-type trans-
former or in-line for 115/230 VAC. It should be plugged into a standard AC wall
outlet that incorporates a ground line.
NOTE: The in-line transformer has a slide switch on the bottom
which is used to select the AC line voltage being used. This switch
must be set correctly.
AN INCORRECT SETTING MAY DAMAGE THE MODEM AND/
OR THE TRANSFORMER.
on
WARNING
:
2240 Fiber Optic Modem
19