Lever For Adjustment Of Cutting Height; Seat; Fuelling - Husqvarna 155, 155 AWD Operator's Manual

Lever for adjustment of cutting height

With this lever the cutting height can be adjusted to
9 different positions.
Combi,
IMPORTANT INFORMATION
In order to obtain an even cutting height it
is important that the air pressure in all four
tires is the same 8,5 psi (0,6 bar).

Seat

The seat has a jointed attachment on the front
edge and can be tipped forward.
The seat can also be adjusted lengthways.
Release the knobs under the seat and adjust it
forwards or backwards to the required position.
Lock the setting with the knobs.
Refueling
The machine has one fuel tank, just behind the
seat. The tank capacity is 1,8 gallons (7 liters).
The engine will run on a minimum of 85-octane
unleaded gasoline (no oil mix). Environmentally
adapted alkylate gasoline can be used. See also
Technical Data concerning ethanol fuel. Methanol
fuel is not allowed.
WARNING!
Gasoline is highly flammable.
Observe caution and fill the tank
outdoors (see the safety rules).
WARNING!
The engine and the exhaust
system, become very hot during
operation. Risk for burns if
touched. Allow engine and
exhaust system to cool at least
two (2) minutes before refueling.
WARNING!
Fill to bottom of filler neck. Do not
overfill. Wipe off any spilled oil or
fuel. Do not store, spill or use
gasoline near an open flame.
When operating in temperatures below 32° (0° C.),
use fresh, clean winter grade gasoline to help
insure good cold weather starting.
CONTROLS
40-90 mm
(1 9/16" - 3 9/16")
6004-013H
6004-014H
6004-015
21
English –