Adjusting The Parking Brake; Adjusting The Throttle Wire - Husqvarna 11 C Operator's Manual

Adjusting the parking brake Rider 13
C, Rider 16 C
Check that the brake is correctly adjusted by placing the
machine on a slight downhill slope with the clutch disengaged
and activating the brake.
When the machine does not stand still, the brake should be
adjusted according to the following.
1 Loosen the locking nuts (1).
2 Tension the cable using the adjuster screw (2) until the
play in the cable is taken up.
3 Tighten the locking nuts (1).
4 The brake should be checked again after adjustment
WARNING! A poorly adjusted brake can
!
result in reduced braking ability.
Adjusting the parking brake Rider 16
AWD
Check that the parking brake is adjusted correctly by placing
the machine on a slope with the front and rear axles
disengaged. Apply and lock the parking brake. When the
machine does not stand still, the parking brake should be
adjusted according to the following.
1 Remove the left-hand wing cover.
Maintenance
1 Loosen the locking nuts (1).
2 Tension the cable using the adjuster screw (2) until the
play in the cable is taken up.
3 Tighten the locking nuts (1).
4 The brake should be checked again after adjustment
5 Assemble the left-hand wing cover.
!

Adjusting the throttle wire

The throttle cable may need to be adjusted, if the engine does
not respond as it should when accelerating, if it produces
black smoke or maximum revs are not reached.
1 Release the clamping screw that secures the wire casing
and set the choke control to maximum choke.
2 Pull the choke wire casing to the far right and tighten the
clamping screw.
WARNING! A poorly adjusted parking brake
can result in reduced braking ability.
– 23
English