Adjusting The Parking Brake - Husqvarna Rider ProFlex 21 Operator's Manual

Adjusting the parking brake

The parking brake (on the right side) is adjusted in the
following manner:
1. Remove the transmission cover. Loosen both
screws (one on each side) and lift off the
transmission cover.
2. Unhook the spring (A) from the screw (B).
3. Check that the parking brake is not on.
4. Adjust the play between the casing and the
adjustment screw to 1 mm when you pull the
casing.
Adjust with the nuts on the adjustment screw.
5. Tighten the nuts moderately to avoid damaging
the threads.
6. Replace the spring (A).
7. Test the brake to ensure that it works.
WARNING!
A poorly adjusted brake can result in
reduced braking ability.
MAINTENANCE
6008-209
A
B
6020-005
37
English-