Deleting Images; Erasing Images One At A Time; Erasing All Images On The Disc - Sony DKR-700 Instructions For Use Manual

Deleting Images

This section describes the operating procedures to be
followed using either the DKR-700/700P front panel
or the RM-C700.

Erasing Images One at a Time

1
Display the image to be erased. (See "Playing or
Searching for Images" on page 26(E) for
procedures.)
2
Press the ERASE button/key.
The ERASE button blinks, and the message
"Erase" appears on the screen.
3
While the ERASE button is blinking , press it (or
the ERASE key) again. If the ERASE button/key is
left for about five seconds, the ERASE button will
stop blinking. It will start blinking by pressing it
(or the ERASE key) again.
The ERASE button lights, and the image
disappears from the screen. The image number of a
deleted image is omitted from the series.
Caution
During erase the BUSY indicator is lit or blinking.
At this point, be careful not to disconnect the AC
power cord from the outlet. If the power is
disconnected, the data on the disc may be
damaged.
ERASE button
ERASE key

Erasing All Images on the Disc

Note
Before beginning the operation, check the images
recorded on the disc. Once images have been erased,
there is no way to recover them.
1
Insert a disc into the DKR-700/700P (see page
18(E)).
2
Press the ALL ERASE/INIT button/key.
The ALL ERASE/INIT button blinks, and the
message "ALL ERASE" appears on the screen.
3
While the ALL ERASE/INIT button is blinking,
press it (or the ALL ERASE/INIT key) again. If
the ALL ERASE/INIT button/key is left for about
five seconds, the ERASE button will stop blinking.
It will start blinking by pressing it (or the ALL
ERASE/INIT key) again.
The ALL ERASE/INIT button lights, and all erase
starts.
Caution
During erase the BUSY indicator is lit or blinking.
At this point, be careful not to disconnect the AC
power cord from the outlet. If the power is
disconnected, the data on the disc may be
damaged.
ALL ERASE/INIT button
ALL ERASE/INIT key
37(E)