Sony DKR-700 Instructions For Use Manual page 13

Remote connectors (rear panel)
1 DIP switch
Used to set the SCSI-ID and operation mode.
2 SCSI connectors (50-pin, half-pitch)
Used to connect to a computer to exchange image data.
For the electrical specification of these connectors, see page
50(E).
3 RS-232C connector (D-sub 9-pin)
Used to provide external control of the DKR-700/
700P, by connection to the optional RM-C700 Remote
Control Unit or to a computer. Select which of the two
is connected using the menus.
For the electrical specification of this connector, see page
49(E).
4 FS1 connector (D-sub 9-pin)
Used to connect an optional FS-30 Foot Switch.
5 FS2 connector (stereo mini-jack)
Used to connect a 1-contact foot switch.
For the electrical specification of this connector, see page
50(E).
SCSI REMOTE
ID
FS2
EX-CTL
RS-232C FS1
FLASH
INPUT
VIDEO S-VIDEO R G
OUTPUT
1 DIP switch
2 SCSI connectors
3 RS-232C connector
4 FS1 connector
⁄
...
B SYNC
Ú
6 EX-CTL (external control) connector (mini-
jack)
Used to control external devices from the DKR-700/
700P.
For the electrical specification of this connector, see page
50(E).
7 FLASH connector (mini-jack)
Used to connect to the external trigger connector of a
flash unit.
For the electrical specification of this connector, see page
50(E).
5 FS2 connector
AC IN
6 EX-CTL connector
7 FLASH connector
Illustration: DKR-700P
13(E)